FLEXOMETER SPECIMEN PREPARATION
» Back to Back to Flexometer Main Page



Flexometer Specimen Preparation

Flexometer Specimen Preparation

Compression Mold

This mold suits all kinds of hardnesses. The unvulcanised rubber gets placed into the mold and then vulcanised inside the press. The rest runs off by the drain channels. In case of a thin coat remaining on the specimen, it has to be cut off before testing the specimen. The mold has six cavities. The compression mold is the one used most frequently.

Injection Mold

Following the name, an injector needle is used to fill the ingredient into the cavities. But since this procedure requires a relatively homogenous mass, it is not suitable for harder rubber materials.

Flexometer Main PageFlexometer Main Page

Flexometer Overview Flexometer Overview

Manual Standard Flexometer Manual Standard Flexometer

Fully Automated Standard Flexometer Fully Automated Standard Flexometer

Ultimate Flexometer - Manual or Fully Automated Ultimate Flexometer - Manual or Fully Automated

For further information or to place an order for the Flexometer Specimen Preparation, please CLICK HERE, call us Toll-Free at: 1.877.884.TEST, or click on the "HOW TO ORDER" Button

» Back to Back to Flexometer Main Page